Installer Forum: Projects
I am a member of the UC San Diego Solar Car Team. We're looking for a lightweight form of protection for our solar cell array, preferably some type of epoxy (no glass - it weighs too much). What...
i am starting to build a 7500 watts system will be splitting into two 3750 watts each for each inverter got permitts i got almost everything racking accessories panels dc ac disconnect wires...
Hi Gentelmen; I have been working on a solar pv system (grid-tie) to be installed on a barge. the barge is spplied by two diesel generators. one is 90KW as a main/standby and the second one is a...
I am exploring the options for mounting flexible monocrystaline panels of my '13 Chevrolet Volt. Unfortunately I have no idea what voltage the traction battery runs at. Any ideas how I could figure...
Has anyone wired a Xantrex AGS to a Honda EU 6500is with remote start?
Ok, I am new to this. I am on my way to starting my own residential solar installation company and I will have plenty of questions. Please be patient.
What do I need to know to find out how much PV I can put in 1 acre?
I have a XantrexGT2.8 in Mexico. Inverter offline & AC voltage fault messages appear. How do i control grid voltage?
Could you give me a range on how much it would cost to ship one pallet of solar panels?
I understand that the array tilt angle is important for a solar PV system. As long as I arrange my array pointing towards sun it should generate the same energy output. Is that correct?
I'm trying to understand the difference between Unirac Solarmount-I (old Clicksys) and Solarmount product line. It looks like they are using a 'beam' instead of 'rail'. Could you tell me pros and...
What is the effect of azimuth for a solar PV system? Does it really matter if my solar array is pointing towards 225dg (45 dg off to west). Could you provide me resources? I am in Denver, CO. Thank...
What are the options for a grid-tied array to continue to generate power in the event of a power outage?
/*-->*/ Hello, I'd like to get a better understanding of the ability of a grid-tied system to produce power when the grid is down. I know that normally in a grid-tied system, it is not possible...
I'm trying to find a table that shows the snow load info in US. Any suggestions?
How does the Enphase D380 know the difference between going single- or three-phase?
I have a 10 Sharp NT-175U1 modules in my solar pv array and I am planning to expand the system by adding two more modules. However, it looks like my supplier can provide me only Sharp NE-170UC1...